Forums Bug Reports Switchbar/Treebar toggling between windows

I am connected to 3 networks, each with channels open. I use switchbar, but this happens also in treebar. If I try toggling between channels (back and forth by clicking the same channel), it works normally -- it toggles between the two. If I try doing the same with the status window and a channel, it works on the second connection, but not the first or third. Instead, it toggles between the second status window and channel. If I try toggling two status windows, it toggles the second status window and previous non-status window. I know that is confusing, so here's step by step.

My Layout:
Status 1
- Channel 1.1
- Channel 1.2
- Channel 1.3
Status 2
- Channel 2.1
- Channel 2.2
Status 3
- Channel 3.1

Channel to Channel (working):
1) Click Channel 1.1
2) Click Channel 1.2
3) Continue clicking Channel 1.2
4) You will notice that it switches back and forth between Channel 1.1 and Channel 1.2. This is expected.

Channel to Status (working):
1) Click Channel 1.1
2) Click Status 1
3) Continue clicking Status 1
4) You will again notice that it switches back and forth between Channel 1.1 and Status 1. This is expected.

Status to Channel (not working):
1) Click Status 1
2) Click Channel 1.1
3) Continue clicking Channel 1.1
4) You will notice that instead of going back and forth between Status 1 and Channel 1.1, it is instead going back and forth between Status 2 and Channel 1.1 even though Status 2 was never clicked.

Status to Channel *with Status 2 instead of 1 or 3* (working):
1) Click Status 2
2) Click Channel 2.1
3) Continue clicking Channel 2.1
4) You will notice that this is correctly going back and forth between Status 2 and Channel 2.1 even though it doesn't work with a different Status window.

Status to Status (not working):
1) Click Channel 1.1 (just so it's the last channel clicked)
2) Click Status 1
3) Click Status 2
4) Continue clicking Status 2
5) You will notice that instead of going back and forth between Status 1 and Status 2, it is instead going back and forth between Status 2 and Channel 1.1 (the last channel clicked).

Ok... first, I haven't done a completely clean install and this may in some way relate to a Window position setting. I will see if I can find any specific cause and if this happens in a completely clean install as soon as I can. I will get back to you on that, but wanted to get the details down while I was seeing it happening.

Even if it's related to a setting, that is still very odd behavior. It should always toggle between the window you are clicking on and the previous window that was clicked on.