I have been battling with mirc for a good hour and a half trying to figure out why some data I am sending over sockets isn't reaching its designated target, and finally narrowed it down. for some reason $ip is just not returning anything at all!

set %variable $ip sets that variable to literally, $ip

and if i try //echo $ip in the status window nothing is returned.

why?

Eurm, does //echo -a $eval($ip,1) return anything?

You could also try doing //!echo $ip

* /echo: insufficient parameters
-


//!echo $ip doesnt return anything either

This thread any use to you?

wow. i typed /localinfo -h and then tried //echo $ip again and it worked

apparently $ip relies on /localinfo being ran first

thats goofy

Well, aslong as it works.