Neeva:

Yes, you need a separate perform for each server (on a different network!)

This thread doesn't apply to you, though. You have the common use case where you can define perform normally for your different groups (networks). You don't have a single network that has multiple separate perform events.

Go into Alt+O -> Connect -> Options -> Perform... and enable perform on connect and select the correct network from the network list and then put the commands for that network in the box.

Note that if your servers are not associated with networks you can add them as a group in Alt+O -> Connect -> Servers


- argv[0] on EFnet #mIRC
- "Life is a pointer to an integer without a cast"